GDB: Unable to find dynamic linker breakpoint function

Need more? See my GDB tutorial: Part 1Part 2Part 3.

You all know how much I loooooooove GDB, so what better thing to write about after a long time away?

If you’re seeing this message:

warning: Unable to find dynamic linker breakpoint function.
GDB will be unable to debug shared library initializers
and track explicitly loaded dynamic code.

and all your stack frames look like this:

0x40000780 in ?? ()

gdb is trying to tell you that it cannot find the relevant ld library for the target it is debugging.


Well, ld ( and is responsible for locating and running all the shared libraries required by your executable. You must tell gdb where the target version of ld lives so that it can successfully track what your executable is up to.

You probably already know that when remote debugging you should have an unstripped copy of your target’s root filesystem available on your host. Then you can point gdb to the copy filesystem and it will be able to “see” the target’s files.

And that means a seamless debugging experience 🙂

Since ld is a system library, you needn’t add the path to this explicitly. Just point to the “root” of the copy filesystem and gdb is clever enough to find it.

To do this, use the sysroot command:

set sysroot /absolute/path/to/copy/of/target/root/filesystem

You can also use:

set solib-absolute-prefix /absolute/path/to/copy/of/target/root/filesystem

as this is simply an alias for the sysroot command.

Often you will see suggestions to use:

set solib-search-path /path/to/target/root/filesystem

However, this is checked after sysroot and is meant to be used for a list of colon separated paths to non-system libraries that you may be using on your target.

E.g. If you use a shared library from a third party for say, graphics, that isn’t part of the root filesystem, then you can set its path here.

One more tip:

If you are already connected to the target executable (with the target remote <ip:port> command), when you set your paths, you will get a useful confirmation of the libraries that are loaded on each command:

set sysroot /opt/target/root/
Reading symbols from /opt/target/root/lib/ 
Loaded symbols for /opt/target/root/lib/
set solib-search-path /home/faye/LIB/target/ 
Reading symbols from /home/faye/LIB/target/ debugging symbols found)...done.
Loaded symbols for /home/faye/LIB/target/ 
Reading symbols from /home/faye/LIB/target/ 
Loaded symbols for /home/faye/LIB/target/

Once you know all your paths are set correctly, you can just add these commands to your GDB init file, to save you typing them in each time you run gdb.

Happy debugging 🙂

Need more? See my GDB tutorial: Part 1, Part 2, Part 3.